Page 11For technical questions, please call 1-800-444-3353.Item 69368
Troubleshooting
Problem Possible Causes Likely Solutions
Ammeter display
reads maximum.
Defective battery. Check or replace battery.
No ammeter reading. 1. No power to engine starter.
2. Battery cables not making connection.
3. Two-amp charge rate being used.
1. Check power and cable outlet connections.
2. Clean battery cables and reset cable clamps.
3. None, meter will not indicate at this rate.
Charging current
not to full output.
1. Battery is partially charged.
2. Defective battery, will not
hold full charge.
1. Continue charging battery.
2. Check and/or replace battery.
Ammeter needle
moves up to full
charge, then drops
to zero. Makes
“clicking” noise.
1. Reversed battery connections.
2. Battery is completely dead.
3. Defective battery.
4. Charge Engine Starter is resetting
itself after circuit overload.
5. Circuit breaker is cycling.
1. Double-check connection polarity.
If wrong, shut off charger and correct
cable lead connections.
2. Continue charging battery.
Charger will continue to reset itself until
the battery reaches a chargeable level.
3. Check and/or replace battery.
4. Wait until Charger automatically resets itself.
5. May be the wrong switch position.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
Parts List and Diagram
Part Description Qty
1 Battery Charger 1
2 Handle 1
3 Wheels 2
4 Axle 1
5 Mounting Foot 1
Part Description Qty
6 Axle Caps 2
7 Axle Brackets 2
8 Snap Ring 2
9 Screw (5x28mm) 4
10 Screw (5x13mm) 6
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not available individually
as replacement parts. Internal parts are not user-serviceable and are not available.
2
9
1
7
5
1
6
3
10
4
8
10
SAFETYOPERATIONMAINTENANCE ASSEMBLY
Comments to this Manuals