Centech 60601 Operations Instructions download pdf (Page 12)

Page 12For technical questions, please call 1-800-444-3353.SKU 98194

To make a miter cut, loosen the Miter 2.



1/4 turn counterclockwise. Press down





move the Table to the desired angle.

The Miter Angle Indicator will indicate

the selected angle. The table will lock

into place at often used miter angles,

including 22.5º, 30º, 45º, and 90º on both

left and right sides.

With the Table adjusted to the desired 3.



the Fence, secure it with the Hold Down

Clamp and make the cut.

Adjusting the Bevel Angle

A bevel cut is one that is at an angle to 1.

the vertical plane of the material.

Bevel cuts can be used to miter relatively 2.

wide and thin material. Bevel cuts can

be used in combination with a miter cut

to form a compound angle. Compound

angle cuts are often used in crown,

picture frames and similar trim materials.

To set the bevel angle, loosen the Bevel 3.



(See Figure 2.) To do this, press in the



turn counterclockwise. Move the blade

assembly left to the desired angle. You

can read the angle on the Bevel Angle









tight.

Make a sample cut in a piece of scrap 4.

and check to be sure the bevel angle

is correct. If it is not, correct the angle

before cutting your work material.

Using the Depth Stop

Depth Stop

Bolt

Figure 2

1. 

cut which does not cut through the work

piece, you can use the Depth Stop Bolt

to control the depth of the cut. (See

Figure 2, above.)

To limit blade assembly travel, turn the 2.

Depth Stop Bolt clockwise. The further

you screw down the Depth Stop Screw,

the shallower the cut will be.

After the desired cut has been made, 3.

return the Depth Stop Screw to its open

position by turning it counterclockwise.

Making a Cut

Observe all safety and planning items 1.

discussed in this booklet. Detailed

instructions on each of the following

steps are discussed in this booklet. Do

not make any cuts until you have read

this entire booklet and are familiar with

the operation of this tool.

2.

blade assembly to come up. Check to



desired miter angle. Check to be sure

the slide lock is released to allow the

blade assembly to slide freely.

Rev 08i

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments

Centech 60601 Operations Instructions Page 12

Comments to this Manuals