Centech 60601 Operations Instructions download pdf (Page 16)

Page 16For technical questions, please call 1-800-444-3353.SKU 98194

Reinstall a new Blade on the Inner 8.

Flange (68A). (See Figure 7.) Be sure to

match the direction marked on the new

blade with the direction marked on the

saw Blade Housing.

Replace the Outer Flange and Arbor 9.

Bolt. Tighten the Arbor Bolt securely

using the Wrench by turning it

counterclockwise.

Rotate the Center Cover back into place 10.

and tighten the Center Cover Fixing Bolt

using the Wrench by turning it clockwise.

11.

Adjusting the Fence

The Fence holds the work piece in a 1.



blade assembly are adjusted in a miter

or bevel angle.

To make accurate cuts, the Fence must 2.

be perpendicular (at a 90º angle) to the

Saw Blade.

Before beginning work, make a test cut 3.

on scrap material with the Table set at

90º.

Check the cut with an accurate square. 4.

You can also reverse the two pieces,

hold the cut ends together, and hold a

good straight edge along the side of the

pieces.

If either test reveals that the cut is not 5.

a true 90º angle, you must adjust the

Fence before beginning work.

6.

7.



8.

the table with one edge along the blade

and the other along the Fence. Any

inaccuracy should be visible. NOTE:

The square must contact the surface of

the blade, not the teeth, for an accurate

reading.

The Fence is held in place with bolts at 9.



gently tap the Fence into position using a

soft mallet. Retighten the bolts and make

another test cut. Repeat the process until

the Fence is adjusted accurately.

Once the Fence is accurately adjusted, 10.



one last time, then proceed to work.

REV 08k

Figure 7

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments